Flat, stable, uncoupled

Floor tile, start to finish.

Floor tile fails for three reasons: the joists flex, the subfloor is not flat, or the tile is bonded rigidly to a plane that moves. Handle those three and the setting is the easy part.

7
Phases
3–5
Working days
L/360
Deflection
1/8" in 10 ft
Flatness
Tools you will need
  • Tape measure, chalk line, 3-4-5 square
  • 6 ft straightedge or 10 ft level
  • Notched trowel matched to the tile
  • Mixing paddle and drill
  • Wet saw with a porcelain blade
  • Grout float, sponges, buckets
  • Lippage clips and wedges
  • Knee pads, dust mask, eye protection
What to buy0/8
Plain words · what the jargon means
Thinset
The cement glue that sticks tile to the wall or floor. It comes as a powder you mix with water.
Mastic
Ready-mixed glue in a tub. Fine for a dry backsplash, never in a shower or tub surround.
Slake
A 10 minute rest after the first mix so the water soaks into the powder, then you stir again.
Notch
The tooth size on the square-notched trowel. A bigger notch leaves thicker ridges of mortar.
Back-butter
Spreading a thin flat layer on the back of the tile so it grabs the ridges on the wall.
Coverage
How much of the tile back actually touches mortar. 80 percent in dry rooms, 95 percent in a shower.
Pot life
How long a mixed bucket stays usable. Past that it is dead, not just thick.
Skinned over
A dry film that forms on spread mortar. Tile will not bond to it, so scrape it off and recomb.
Lippage
One tile edge sitting proud of its neighbour, enough to catch a fingernail.
AFF
Above finished floor: the height measured once the new tile is actually down.
Substrate
Whatever sits under the tile: backer board, drywall, plywood or a slab.
01

Survey & plan

Half a day0/4 done

Check the joists, check flatness, then decide where the layout lines start.

Check deflection before you buy tile

Tile needs a stiff floor: L/360 for ceramic and porcelain, L/720 for natural stone. Read the joist size, spacing and clear span, then check a span table or the manufacturer's calculator. If the floor is marginal, add a beam, sister the joists, or choose a different floor finish.

  • L/360 ceramic
  • L/720 stone
  • Span, not room size

Measure flatness, not just level

Drag a 10 ft straightedge or a long level across the room in both directions. Small tile tolerates about 1/4 inch in 10 feet; large format wants 1/8 inch in 10 feet. Out-of-flat floors get patched, ground, or floated with self-leveler.

  • 1/4" in 10 ft small tile
  • 1/8" in 10 ft large format
  • Check both directions

Pick the layout origin

Choose the wall or threshold you see first, and center the field on it. Cuts should be at least a third of a tile at every wall, so shift the layout rather than accepting a sliver. Long rooms look better with joints running the long direction.

  • Center on the sightline
  • Cuts ≥ 1/3 tile
  • Run joints with the room

Plan the transitions and door clearance

Measure the height you are adding: tile, mortar, membrane. Then check door swing and undercut the jamb or shorten the door. Decide the transition at every threshold now: a T-molding, a stone saddle, or a flush reducer.

Checking your access…