Backsplash & tub surround
Wall tile, start to finish.
Wall tile is mostly a layout problem. On a backsplash the eye lands on the range or the sink, so the field centers there and the cuts go to the corners. In a tub surround the rules change, because the wall gets wet.
- 7
- Phases
- 2–4
- Working days
- Focal point
- Layout datum
- Modified thinset
- Mortar
Tools you will need
- Tape measure, level, chalk line
- Notched trowel (1/4 x 1/4 or 3/16 v-notch for mosaic)
- Mixing paddle and drill
- Wet saw and diamond hole saw for outlets
- Grout float, sponges, buckets
- Rubber grout float for mosaic sheets
- Silicone gun and tooling tool
- Painter's tape, spacers, wedges
What to buy0/8
Plain words · what the jargon means
- Thinset
- The cement glue that sticks tile to the wall or floor. It comes as a powder you mix with water.
- Mastic
- Ready-mixed glue in a tub. Fine for a dry backsplash, never in a shower or tub surround.
- Slake
- A 10 minute rest after the first mix so the water soaks into the powder, then you stir again.
- Notch
- The tooth size on the square-notched trowel. A bigger notch leaves thicker ridges of mortar.
- Back-butter
- Spreading a thin flat layer on the back of the tile so it grabs the ridges on the wall.
- Coverage
- How much of the tile back actually touches mortar. 80 percent in dry rooms, 95 percent in a shower.
- Pot life
- How long a mixed bucket stays usable. Past that it is dead, not just thick.
- Skinned over
- A dry film that forms on spread mortar. Tile will not bond to it, so scrape it off and recomb.
- Lippage
- One tile edge sitting proud of its neighbour, enough to catch a fingernail.
- AFF
- Above finished floor: the height measured once the new tile is actually down.
- Substrate
- Whatever sits under the tile: backer board, drywall, plywood or a slab.
Plan the elevation
The focal point, the top line, the outlets and the trim decide the whole layout.
Find the focal point
On a kitchen backsplash that is the center of the range or hood. On a vanity wall it is the center of the sink. Center the field there and let the cuts fall at the ends, at least a third of a tile at each.
- Centered on the range or sink
- Cuts at both ends
- Grid matches the counter
Decide the top line and the outlets
Backsplash height is usually the bottom of the upper cabinets, or full height to the hood or ceiling. Mark every outlet and switch, and decide whether they land on a grout joint. If the new tile is thicker than the old, plan for outlet extenders.
- Top line marked level
- Outlets on joints where possible
- Check trim thickness
Pick the edge treatment
Exposed edges need something: a metal profile matched to the tile thickness, a bullnose, a mitered return, or a wood or stone trim. Decide before setting, because it changes the field width by a half inch.
Checking your access…