Tool 01

Layout studio

Enter the surface and the tile, then choose a pattern. The drawing shows the centered field and shades every tile that has to be cut, so the tricky corner shows up here instead of mid-bag of mortar.

Start from a surface

Surface size

Tile size (inches)

Tile orientation

Vertical stands the long side up the wall; horizontal runs it along the surface. Both use the same tile, just rotated, and the field and cut counts update.

Pattern

Joints line up both ways. Simplest to set and the least forgiving of an out-of-square room.

Notes for this surface

  • Center the field on the valve wall and carry the joints around the inside corners.
  • Set walls off a level ledger at the second row, then cut the bottom row to the pan.
  • Bottom cut should be at least half a tile: move the ledger, not the cut.
Plan view12" × 24" tile · 0.13" joint
full tile cut tile

60" × 96"

Order

22

20 in the field, 10% waste

Full tiles

6

Cut tiles

14

Pattern

0°

Square to the walls

Edge cuts

Left

11.75"

Right

11.75"

Top

23.81"

Bottom

23.81"

Both ends match at 11.75", which means the field is centered. Keep the smallest cut above a third of the tile: at 12" wide that is 4".

Numbers assume square walls and no obstructions. Check the real room with a level before ordering.